Multifunction Car Jump Starter 12v Car Jump Start Kits

Model Number: LW-CTK002 Brand Name: Our own brand Key Specifications/Special Features: Jump starter operation manual:I.The red clip of storage battery wire clip is connected to the positive battery terminal and theblack clip to the negative battery terminal;II.The plug is connected to start power;III.Start the car;IV.Remove the plug from the start power;V.Remove the clamps from the car battery.Tire pumpoperation manual:I.Insert the valve of tire directly.When you hear the sound of airmission in the tire, it show that air is being in circulation. And then, tighten clip,in order tocombine the mouth of pump with the tire’s closely;
II.Insert other side of EC5 female into the start power EC5 male;
III.Put on the power switch, and then charging is begin. Normally, the tire pressure is 2.5 KG;
IV.During the charging, meter hand is going up with the speed of air pressure. When the biggermeter hand reach at the reasonable tire pressure, turn off the switch of tire pump and take out theplug and mouth;
V.Some attachments back of the tire pump are used in charging for ball, air bed and otherequipment.
Attention: It can reach at the normal air pressure about one minute.General, the charging time cannot be over 8 minutes .
Electric car jack operation manual:
I.Use the kickstand to fix the tire in order to avoiding movement;
II.Insert the plug into the jack of the start power;
III.Put the electric car jack under the chassis frame;
IV.Press on the “^” switchboard and raise up the whole car until the car beseparated from the land;
V.Choose the electric impact wrench to loose the screws;
Vi.Unload the tire and replace it with spare tire, and then use the electric impact wrench to tightenthe screws;
Electric impact wrench operation manual:
I.Keep the car engine on in order to guarantee power supply ;
II.Insert the plug into the start power or connect with car battery;
III.Choose the proper socket for the wrench’s shaft ;
IV.According to the working direction, choose the loosening or tightening switch.
Attention:12V automotive power only can be used ;During operation, you should keep the carengine on; working time should not be over 10 minutes one time; don’t touch the sleeve headduring operation; note the positive and negative, when you using the car battery clip .